Digital Drawing Tablet
Drawing Monitor
Drawing Pad
3D Printer
Accessories
Support
Please select your country/region
North America
South America
Oceania
Europe
How to fix layer shifting or layer stacking?
1. Printing speed too high: Refer to Section 3.1.2 Advanced Printing to reduce print speed. In Standard mode, the default speed is 300 mm/s — try reducing by 10–20 mm/s and observe.
2. Over-extrusion: If adjusting speed doesn't help and layer stacking remains severe, reset the parameters as follows:
a. Refer to Section 3.1.2 Advanced Printing, go to the print settings page, and tap "Restore Defaults" to reset to factory parameters.
b. Refer to Section 3.3.1 Calibration and Leveling and re-run calibration and leveling.
Please select your country/region
North America
South America
Oceania
Europe
