빠른 조회
디지털 드로잉 태블릿
드로잉 모니터
태블릿 PC
국가 / 지역을 선택하십시오
North America
South America
Oceania
Europe
빠른 조회
디지털 드로잉 태블릿
드로잉 모니터
태블릿 PC
국가 / 지역을 선택하십시오
North America
South America
Oceania
Europe
How to fix spaghetti or failed 3D prints?
If you find a spaghetti mess after printing, the cause is usually the print head nozzle scraping against the model during printing.
1. Print head position too low: Refer to Section 3.3.1 Calibration and Leveling to re-run calibration and leveling.
2. If spaghetti occurs again after re-leveling, it may be caused by warping during printing. Refer to Section 3.1.2 Advanced Printing and try reducing the nozzle temperature or print speed.
국가 / 지역을 선택하십시오
North America
South America
Oceania
Europe