빠른 조회
디지털 드로잉 태블릿
드로잉 모니터
태블릿 PC
국가 / 지역을 선택하십시오
North America
South America
Oceania
Europe
빠른 조회
디지털 드로잉 태블릿
드로잉 모니터
태블릿 PC
국가 / 지역을 선택하십시오
North America
South America
Oceania
Europe
How to fix layer shifting or layer stacking?
1. Printing speed too high: Refer to Section 3.1.2 Advanced Printing to reduce print speed. In Standard mode, the default speed is 300 mm/s — try reducing by 10–20 mm/s and observe.
2. Over-extrusion: If adjusting speed doesn't help and layer stacking remains severe, reset the parameters as follows:
a. Refer to Section 3.1.2 Advanced Printing, go to the print settings page, and tap "Restore Defaults" to reset to factory parameters.
b. Refer to Section 3.3.1 Calibration and Leveling and re-run calibration and leveling.
국가 / 지역을 선택하십시오
North America
South America
Oceania
Europe