Digitales Zeichentablett
Zeichnungsmonitor
3D-Drucker
Unterstützung
Bitte wählen sie ihr land / ihre region aus
North America
South America
Oceania
Europe
How to fix layer shifting or layer stacking?
1. Printing speed too high: Refer to Section 3.1.2 Advanced Printing to reduce print speed. In Standard mode, the default speed is 300 mm/s — try reducing by 10–20 mm/s and observe.
2. Over-extrusion: If adjusting speed doesn't help and layer stacking remains severe, reset the parameters as follows:
a. Refer to Section 3.1.2 Advanced Printing, go to the print settings page, and tap "Restore Defaults" to reset to factory parameters.
b. Refer to Section 3.3.1 Calibration and Leveling and re-run calibration and leveling.
Bitte wählen sie ihr land / ihre region aus
North America
South America
Oceania
Europe
